I would like to do this with the Shapeoko mm post-processor but I cannot get it to work. When I save a program with multiple tools I am simply trying to add the ability to auto-populate the M6 prompt via the post-processor so my G code sender will automatically prompt for a tool a change. The entry worked just fine in the previously mentioned Gcode.pp but i would like it to work with the Shapeoko.pp. Per your question, I used a different.pp simply to test things out and see if my entry was the problem. The error message is popping up when I first open v-vectric.Įxpected 'begin SECTION' or 'end SECTION' to terminate current sectionĬ:\ProgramData\Vectric\VCarve Pro\V9.5\My_PostP\Shapeoko_mm.ppĪs long as the post-processor is using gcode it should not matter which one I use specific to the machine or not as long as it populates a code that works with the sender and machine. POST_NAME = "Shapeoko_TCM6 (mm) (*.gcode)" + Grbl - Vectric machine output configuration file How do I add the M6 Command into one of the post-processors that will populate the Gcode format that has a lot of "G0 X Y Z " and work well with CNCjs/Shapeoko XXL 3?Īny directions, lessons, or advice anyone might have in regards to any of this would be greatly appreciated. tap file means in this situation but the Gcode was different then I have been trying to learn, such as, "X100.407Y254.294". I had success with auto-populating the M6 command and confirmed that the M6 command was in the code. When saved and Vectric Pro is re-opened I get an error message from Vectric about the adjust.
I inserted the correct commands into the Shapeoko (mm).
0 kommentar(er)
